Services
Product Engineering and Validation
We connect product architecture, design, analysis and validation through shared requirements. We coordinate technical decisions from geometric interfaces through test results.
Product Engineering and Validation
Vehicle and Product Architecture, Systems Engineering and DMU/DPA
We manage requirements, system interfaces and geometric constraints together within the product architecture.
Scope
- Product and vehicle packaging, layout and component positioning
- System and subsystem interfaces; vehicle line and vehicle DNA
- DMU clash and geometric integration checks; decision coordination across cross-functional DPAs
- Pre-release part checks and reporting of homologation impacts
- Engine compartment, tyre clearance and envelope checks; ground clearance and vehicle ride height targets
- Master section development and verification; change impact and manufacturability inputs
Typical deliverables
- Package model
- Digital technical decision coordination
- DMU issue list
- Vehicle line
Product Engineering and Validation
CAD and Product Design
We turn concept intent into controlled engineering data that manufacturing and the supply chain can use.
Scope
- Parametric solid and surface modeling
- Part, assembly and joining solutions
- Technical drawings and manufacturing data preparation
- Embedding manufacturability and assembly requirements in the design
- Revision-controlled CAD data
- Supplier and manufacturing handover support
Typical deliverables
- 3D CAD dataset
- Assembly design
- Technical drawings
- Revision package
Product Engineering and Validation
CAE and Engineering Analysis
We support design decisions with numerical analyses grounded in physical behavior and load cases.
Scope
- Linear and nonlinear structural analysis
- Strength, fatigue and service life assessment
- Thermal and flow analysis
- Noise, vibration and harshness (NVH) and dynamic behavior studies
- Multibody systems and vehicle dynamics
- Optimization and design iteration
Typical deliverables
- Model and assumptions
- Critical area analysis
- Design recommendation
- Technical report
Product Engineering and Validation
DVA/GD&T and Tolerance Management
We turn geometric requirements into a measurable, manufacturable tolerance strategy.
Scope
- Datum strategy and geometric dimensioning and tolerancing (GD&T)
- 1D and 3D tolerance stack-up
- Statistical variation analysis
- Gap and flush and assembly risk
- Definition of critical characteristics
- Definition of measurement and inspection criteria
Typical deliverables
- Datum scheme
- Tolerance stack-up
- Variation report
- Measurement plan
Product Engineering and Validation
Testing, Validation and Homologation
We plan and coordinate the validation chain from requirements through technical closure.
Scope
- Requirements and regulatory matrix
- Design verification plan and report (DVP&R)
- Test method, sample, fixture and measurement plan
- Prototype, vehicle and subsystem testing
- Results evaluation and root cause analysis
- Assessment and reporting of homologation impacts
Typical deliverables
- DVP&R
- Test specification
- Results report
- Compliance matrix
LEADVISION